Corsair RM850x SHIFT

An 850 W ATX 3.1 power supply with the connectors on the side panel, fully modular Type 5 cables and a 10-year warranty.

Corsair RM850x SHIFT

Full Specification Sheet

Wattage850 W
Efficiency80 PLUS Gold (Cybenetics Gold efficiency, Cybenetics Noise A)
ModularityFully modular, side-mounted connectors, Type 5 cables
Fan140mm fluid dynamic bearing, Zero RPM mode
StandardsATX 3.1 certified, PCIe 5.1 12V-2x6 cable included
Form FactorATX (160 x 150 x 86 mm)
+12V Rail70.8 A (849.6 W)
Capacitors100% Japanese 105 degC electrolytic
Warranty10 years

The Corsair RM850x SHIFT is an 850-watt, fully modular ATX power supply whose defining feature is the position of its cable connectors. Instead of being on the rear face, where they face the motherboard tray and are hard to reach in a crowded case, the modular sockets sit on the side of the unit. Corsair calls this a patent-pending side interface, and it is the reason the RMx SHIFT series exists. Beyond that idea, the unit is a conventional 80 PLUS Gold power supply with ATX 3.1 certification, a 140 mm fan, Japanese capacitors and a ten-year warranty. This page goes through the published specification and explains what each part means for a build.

The side connector design

With most modular power supplies, you reach around the back of the unit, behind the motherboard tray or beside the cable-management space, to plug in each cable. Corsair moved the sockets to the side panel so that they face outward and are accessible from the side of the case. The trade-off is clearly stated in Corsair's own compatibility notes: the power supply and its cables fit in any case that supports the ATX power supply format and is at least 210 mm (8.3 inches) wide, and the power supply must be accessible from the side when mounted. That effectively means a case whose power supply chamber is open on the side facing the cable-management space, and Corsair publishes a list of compatible cases. Check the list or your case manual before buying, because a case with a sealed or offset power supply shroud may not allow access. The unit uses Corsair Type 5 Gen 1 micro-fit cables, and Corsair states on the unit that it is designed for use with genuine Corsair Type 5 cable sets only; the side sockets are labelled for the motherboard, PCIe and CPU, and SATA/PATA connectors. Our guide to modular PSUs and cable management explains why easier access matters in tight builds.

Power, rails and efficiency

Corsair specifies 850 W of continuous power. The rail table lists +3.3 V at 20 A and +5 V at 20 A with a combined limit of 150 W, +12 V at 70.8 A for 849.6 W, and +5 V standby at 3 A for 15 W. The single +12 V rail carries essentially the whole output, which is the design used by most modern PSUs because processors and graphics cards draw almost entirely from 12 V. AC input is 100 to 240 V at 10 A to 5 A and 47 to 63 Hz. The unit carries the 80 PLUS Gold certification, which Corsair describes as steady power output at up to 90 percent efficiency, and it is also certified by Cybenetics for efficiency at Gold level and for noise at level A. The mean time between failures is 100,000 hours. It supports Modern Standby. To understand how the efficiency ratings differ, see our explainer on 80 PLUS tiers, or, for the wattage question, our guide on how much PSU wattage you need.

ATX 3.1 and the 12V-2x6 cable

The unit is formally certified for ATX 3.1 compliance, which raises the standard for reliability and power efficiency; Corsair notes that many of its power supplies meet these requirements but the RMx SHIFT series is formally certified. It includes a PCIe 5.1 12V-2x6 graphics cable, 650 mm long, for modern graphics cards that use that connector. The ATX12V version is listed as 3.1 and the EPS12V version as 2.92. Because the 12V-2x6 connector carries a large current through a small plug, seat it fully, avoid tight bends near the connector and use the cable supplied with the unit. Our article on the 12VHPWR and 12V-2x6 connector describes the reasons.

Cable set

The bundled cables are flat ribbon types. There is one 24-pin ATX cable of 610 mm, two 8-pin EPS/ATX12V CPU cables (4+4) of 650 mm, one 12V-2x6 cable of 650 mm, one PCIe 8-pin (6+2) cable with two connectors totalling 750 mm, and two single-connector PCIe 8-pin (6+2) cables of 650 mm. That gives four PCIe 8-pin connectors in addition to the 12V-2x6 cable. Storage power comes from three SATA cables with four connectors each, giving twelve SATA connectors, and two four-pin PATA cables with four connectors each, giving eight. Lengths are given with a tolerance of 10 mm. For a typical single-graphics-card build, that is more than enough; if you plan several drives, count the connectors before choosing a case.

Cooling, build quality and size

The fan is 140 mm with a fluid dynamic bearing and a Zero RPM mode, so the fan can stay stopped at light loads and the unit can be silent. Corsair uses 100 percent industrial-grade Japanese electrolytic capacitors rated for 105 degrees Celsius. The unit measures 160 mm by 150 mm by 86 mm and weighs about 3 kg. The 150 mm width is the standard ATX unit width, but the side-connector layout means the case requirement described earlier is more important than the length.

Choosing the wattage

Corsair offers the RMx SHIFT design in 750 W, 850 W, 1000 W and 1200 W versions, and a white edition also exists. Choosing 850 W is a matter of matching your parts to the load. As one published reference point, NVIDIA lists 650 W as the required system power for its GeForce RTX 5070 and 750 W for the GeForce RTX 5070 Ti, in both cases for a PC configured with a Ryzen 9 9950X processor. An 850 W unit therefore leaves headroom above those figures for a mid-range or high-end gaming build, and an efficient supply also tends to run cooler and quieter when it is not near its limit. Add up the rated power of your processor and graphics card, allow for drives and fans, and choose a size that leaves a comfortable margin; there is no benefit in buying far more capacity than you will use.

Warranty and price

Corsair backs the RM850x SHIFT with a ten-year warranty. Prices vary by region and change with promotions, so we do not quote one. Compared with the be quiet! Straight Power 12 1200W already listed on this site, the RM850x SHIFT has lower capacity and a different efficiency class, but it is a more modest power draw for most gaming builds. See the RM850x SHIFT versus RM850x comparison for how it differs from Corsair's conventional-layout RM850x, and browse power supplies for other options.

Who should consider it

The RM850x SHIFT suits builders who want a straightforward, quiet 850 W Gold unit and who value simpler cable installation, provided their case is on Corsair's compatibility list. It is less suited to small or unusual cases, or to builders who prefer the widest choice of aftermarket cable sets. All specifications come from Corsair's product page; availability and configuration vary by region.

Product image: CORSAIR product image.