be quiet! Pure Power 12 M 850W (BN756)

An 850 W modular ATX 3.0 power supply with 80 PLUS Gold efficiency, two 12 V rails, a native 12V-2x6 connector, a 120 mm silence-optimised fan and a ten-year warranty.

be quiet! Pure Power 12 M 850W (BN756)

Full Specification Sheet

Wattage850 W continuous (900 W peak)
Form FactorATX, 160 x 150 x 86 mm
StandardATX 3.0, PCIe 5.1 compatible, EPS12V 2.92
Efficiency80 PLUS Gold, up to 93.2% (230 V, 50% load)
TopologyLLC + SR + DC/DC
Fan120 mm be quiet! fan, rifle bearing, max 2000 rpm
Noise9.3 to 9.5 dB(A) up to 50% load, 25.7 dB(A) at 100% load
Rails2 x +12V (40 A / 36 A), +3.3V 22 A, +5V 22 A, +5Vsb 3 A
GPU Cable1 x 12V-2x6 (600 W) and 4 x PCIe 6+2-pin
ModularityModular, sleeved cables for 24-pin and 12V-2x6
ProtectionOTP, OCP, OPP, SCP, OVP, UVP, SIP
Warranty10 years

The be quiet! Pure Power 12 M 850W (article number BN756) is a modular ATX power supply from be quiet!'s Pure Power 12 M line. The manufacturer's headline is exceptional quiet and superior features, and its description stresses ATX 3.0 compliance, PCIe 5.1 compatibility and 80 PLUS Gold efficiency of up to 93.2 percent. Every figure below comes from be quiet!'s own product page and its data table. Where the page describes a quality in marketing language, we say so, and we make no claim that the unit has been tested by us or by anyone else. The recommended retail price the manufacturer lists is 149.90 euros; we show no US price because the page gives none.

Power rating and rails

The unit provides 850 W of continuous power and lists 900 W as peak power. Its output is delivered by two independent 12 V rails: +12V1 is rated at 40 A and +12V2 at 36 A. The maximum combined 12 V power is 850 W, and the +3.3 V and +5 V rails are each rated at 22 A, with a combined limit of 120 W for the two. The +5 V standby output is rated at 3 A and the -12 V rail at 0.3 A. When a power supply splits its 12 V capacity across separate rails, each rail has its own over-current protection threshold, so a heavy component should be spread across the outputs rather than concentrated on one cable. The AC input is 100 to 240 V at 50 to 60 Hz with an input current of 12 A at low line and 6 A at high line, and the power factor at 100 percent load is 0.98. If you are unsure how much capacity a build needs, our guide to how much PSU wattage you need shows how to work it out.

ATX 3.0 and the 12V-2x6 connector

be quiet! describes the unit as an ATX 3.0 power supply with native integration of the 12VHPWR connector for PCIe 5.1 graphics cards. The data table lists one 12V-2x6 cable, rated at a maximum combined power of 600 W, alongside four PCIe 6+2-pin connectors for cards that use conventional 8-pin power, so the same unit serves both current and older graphics cards. The manufacturer also states that the power supply handles power excursions up to double its rated power. That is a claim about transient loads, the brief spikes that modern graphics cards can produce, and it is offered without a test method on the page. For background on the connector and why it matters, read our explainer on the 12VHPWR power connector.

Efficiency and certification

The unit is certified 80 PLUS Gold. The data table lists measured efficiency at 230 V: 73.8 percent at 2 percent load, 87.1 percent at 10 percent load, 91.7 percent at 20 percent load, 93.2 percent at 50 percent load and 91.2 percent at 100 percent load. The 93.2 percent figure at half load is the number behind the up to 93.2 percent claim. Efficiency describes how much of the power drawn from the wall reaches the components, and the rest is turned into heat; a curve like this one peaks in the middle of the load range and falls at both ends. Because it is measured at 230 V, values at 115 V mains can differ. Our article on 80 PLUS tiers from Bronze to Platinum explains what the tiers do and do not tell you.

Fan and noise data

The cooling is a silence-optimised 120 mm be quiet! fan with a rifle bearing and a four-pole motor, temperature-controlled, with a maximum speed of 2000 rpm. The page publishes noise levels in dB(A): 9.3 at 10 percent load, 9.4 at 20 percent load, 9.5 at 50 percent load and 25.7 at 100 percent load. These are manufacturer figures whose test conditions are not described on the page, so treat them as an indication of how the fan curve rises at full load rather than a promise about your case. The airflow-optimised blades are said to reduce turbulence. The operating temperature is specified up to 40 degrees Celsius, and the stated average lifetime is 100,000 hours at 25 degrees Celsius.

Topology, hold-up and protection

Inside, be quiet! lists an LLC plus synchronous-rectification plus DC/DC topology, which the manufacturer says gives best-in-class voltage regulation and efficiency. Hold-up time is 20.6 ms at 100 percent load and 24.9 ms at 80 percent load, which is the period the unit can keep its outputs in regulation after mains power is lost, and the power-good signal is 100 to 150 ms. Standby power consumption is listed as 0.1 W. Protections listed are over-temperature, over-current, over-power, short-circuit, over-voltage, under-voltage and surge and inrush protection. The safety certification list includes BSMI, CB, CCC, CE, cTUVus, cRUus, CU, FCC, RCM, TUV, UKCA and IRAM, and the environmental directives include Energy Star 8.0, ErP, WEEE, RoHS and Triman.

Cables and connectors

The unit is modular, so only the cables a build needs are connected. The 24-pin cable and the 12V-2x6 cable are sleeved, while the CPU, PCIe and drive cables are flat. The table lists one 24-pin motherboard cable, one 4+4-pin CPU cable, one 8-pin CPU cable, one 12V-2x6 cable, four PCIe 6+2-pin connectors, six SATA connectors and two PATA connectors, eight cables in total. The longest cable is 95 cm and the cable to the motherboard is 55 cm, which should be checked against the case if it is large. Cable management is easier with modular cables because unused leads never enter the case, as we discuss in our guide to modular PSU cable management.

Size, weight and warranty

The housing measures 160 by 150 by 86 mm without cables, which is the compact end of ATX depth, and the unit weighs 1.85 kg. It is black. The warranty is ten years, with an express replacement service in the first year and an international hotline that is free of charge, listed for Germany, France and the United States. The scope of delivery includes screws and cable ties, and the user manual is available in nine languages.

Where it fits

With 850 W, two 12 V rails and a native 12V-2x6 connector, this model targets mainstream gaming and content-creation builds that value a quiet fan curve. For a larger unit from the same maker, see the be quiet! Straight Power 12 1200W, and for a direct look at the numbers use the side-by-side comparison. The full range is in the power supply category. Everything above is a published specification, not a test result.